Every Low PPM Nanoparticle Colloidal Silver producer will tell you that "their product is the correct product."

The FACT is that they will offer information that is manipulated to give their products a "Golden Glow" will providing misinformation about others.

Knowing the chemical content of products you are going to ingest should be of great concern to you because they have Dangerous LONG TERM SIDE EFFECTS.​​
We are explaining these SHOCKING chemical facts about the Low PPM Producers because they want you to believe that they do not have chemicals when, in fact, most do.
Producers of colloidal silver that use chemicals will try to persuade you to believe that their CS is the best and explain that it must be "this color, or that color" or that "It must react this way or that way." 

BEWARE that is a False Flag Warning, and you must carefully do your research.

Some sellers will tell you that Clear Colloidal Silver Solutions are Ionic, when in fact, it takes a chemical process to break down the silver into IONS. There is ALWAYS a color change that accompanies this process.

Others will tell you that IONIC solutions do not reflect light, that is another outright misrepresentation of the facts. 

The only particle size (in colloidal silver solutions) that does not reflect light are Atomic Particles. Why?

1. Silver Minerals are atomic size particles

2. The atomic particles are way too small to reflect light, so the solution will be clear as water.

There are hundreds of chemical and herbal catalysts that can be used to make colloids, in fact, some producers use Embalming Chemicals (see the patents below).

Depending on the chemical or catalyst used, it will determine the color and additional chemicals will be produced AFTER the electrolysis process is over.

There are other NON-Chemical means that also produce toxic chemicals such as Herbal Extracts that are used as Catalysts that still produce massive useless particles and chemicals.
Chemical Compounds

Chemicals lead to Baldness
Chemicals cause premature gray hair
Mostly everyone knows that hydrogen peroxide is used to dye hair, but it also causes premature gray hair.

When hydrogen peroxided is ingested, it will accelerate the loss of the pigment that is required to maintain hair color, and, as a result, gray hair is produced. Many producers use hydrogen peroxide in colloidal silver as well as colloidal gold.

Hair Loss. aka HCL is used in hundreds of prescription medicines, when you read about the side effects on the label they all have one common side effect, and that is Hydrochloric Acid 
If you do not have any hair, this may not be of any concern but for those of you that do have hair and want to keep it, this is critical:

Certain Chemicals Cause Hair Loss or Premature Gray Hair, others kill cells on contact!

Many of these chemicals are already in many medicines you take. However, they are also found in many colloidal silver products as reported by the FDA.

For those of you that want to retain your natural skin color, then, this should also be of great concern to you since chemicals can trigger a gene that causes the
graying of the skin.

The FDA reported that Nearly ALL Producers of Colloidal Silver Use Chemicals in fact the FDA found many that were Clear as Water, but had NO Silver At All !

Excerpt from 1999 FDA report

We found these Patents that describe Chemical Use, including Embalming Fluid to make colloidal solutions that explain that chemicals will cause a color change as well as produce nanoparticles:
Colloidal Silver Patent Examples and Gold solutions describing in detail the chemicals used:

Look closely at these three Patent Extracts from the European Patent Office:
The first is................. A Method for Preparing Nano Gold Solution

Applicant: HUANG DEHUAN (CN)
Classification: - international: B22F9/24; B22F9/16; (IPC1-7): B22F9/24
Also published as: CN1302882C (C)

Abstract --- The invention discloses a method of nanometer aurum solution, which includes the following processes, (1) charging chlorauric acid into deionized water, then charging polyvinyl pyrrolidon, sodium dodecyl sulfate, wherein the mass concentration of the chlorauric acid ,polyvinyl pyrrolidon, and sodium dodecyl sulfate being 0.01í 1/2 1.0ú, 0.02í 1/2 2.0ú and 0.0001í 1/2 1.0ú, (2) at room temperature, charging 0.01-0.5% aqueous solution of hydrazine hydrate into the miscible liquid of step (1) while agitating, when the pH reaches 6.8-7.0, ceasing the charge of hydrazine hydrate aqueous solution, continuing stirring 20-30 minutes.

.....................Take special notice of all the chemicals shown in bold in this patent................

The 2nd patent....... Chemical Preparation Method of Ag Nanoparticle
Classification: - international: B22F9/24; B22F9/16;

Abstract --- The invention relates to a method for preparing silver nanometer particles, wherein it is characterized in that: it uses silver nitrate or silver perchlorate as initial reactant; uses sodium oleate or linolic acid sodium as surface activator; mixing them at free ratio; uses toluenedimethylbenzene, and sub dichlorobenzene or chloroform reaction medium; in organic phase, obtaining silver nanometer particles. The invention has simple control, without preparing forward element and organic solvent with high boiling point, with low cost. The inventive silver nanometer particles can be dispersed in non-polar medium and polar medium.

The chemicals in this colloidal silver patent to make silver nanoparticles include TOLUENE a powerful solvent and CHLOROFORM which is an embalming fluid used in funeral homes.

You can see why you want to avoid getting these toxic substances in your body.

The 3rd patent... Method for Preparing Silver Nanoparticle with Multiple Colored Liquid Phase
Classification: - international: B22F9/24; B22F9/16;

Abstract --- The invention relates to a method for preparing several colors of liquid silver nanometer particles, wherein said method comprises that: putting AgNO3 under alkali microwave radiation high-pressure reaction, using alcohol as reducer, with sodium dodecylbenzene sulfonate anion surface activator), processing preparation; changing the solution density, to obtain different liquid silver nanometer particles. The invention has the advantages that: (1), the invention has simple process, only needs family microwave furnace; (2), the material can be obtained easily; (3), it can change solution density to prepare different color liquid silver nanometer particles; (4), the silver nanometer particles have uniform diameters and better stability.

As you can see from the above notation in item number three, part of this patent process is to make various colored solutions with silver nanometer particles.

The fact is that MANY companies outsource their colloidal silver products from China and other countries. How do you know what is in them if they choose not to disclose with accuracy?

Colors of Colloidal Silver
The fact is, there'res many variations of colloidal silver products in the marketplace. Depending on what chemical or catalyst is used, will determine the color of the solution, with silver, there are cloudy somewhat clear colors, to brown and even up to dark grays. With Gold, there are very pretty pinks to dark purple colors.

Maybe you are saying to yourself:

"I buy my colloidal silver from a Doctor Endorsed company, yeah, it's low PPM, but they say they do not use chemicals."

We have looked into those arguments and companies that claim that they do not use chemicals and we have an explanation for that:

1. Nanoparticles are way too heavy to stay suspended in the solution; the solution has to be "Thickened" and they do it with chemicals or "Herbal" Catalysts.

2. While Herbal Catalysts sounds like its an "Organic" product, they fail to explain to you is the reason they have weird color solutions is that Herbal Catalysts (however natural they may be) still contain: salts, good and bad minerals, and even enzymes. After the Electrolysis process is over, they still produce chemical compounds and color changes to the solution.

3. Most of those Doctors have vested interest in the companies they promote.

Most colloidal silver solutions with ionic size particles claiming to have a high PPM content look ugly with an unappealing dark color. Also, they’re foamy and slimy to the touch, which is very comparable to way soap feels.​

Companies offering a high PPM, ionic silver solutions, often use Phosphates or Bromides to make their products. Both of these substances cause false readings when analyzed for the PPM content.

So in actuality, you could be getting much lower PPM content that is being claimed. Something purposefully not mentioned, is both phosphates and bromides are found in numerous soap products. What this means, is that by ingesting ionic colloidal silver (that utilized phosphates or bromides to make the product), you’re essentially consuming SOAP ingredients. Ingesting colloidal silver that contains soap-based ingredients is very bad for your health, not to mention they are not Kosher. 
In the image above you can see the repulsive, ugly looking chemical compound, yet many producers still claim they don’t use or have chemicals in their products. When chemical methods are used to make Ions and Nanoparticles in a solution, it causes a distinctive color change. The colors can vary considerably depending on what chemicals were used.
Colloidal silver makers often claim they use purified water to make their products and solutions. The problem is even by using Reverse Osmosis, there still remains minerals as well as sodium. Sodium can then convert to silver chloride which is a well-known chemical.

The other minerals may convert to other types of chemical compounds, so if cadmium or fluoride is there, then you can expect other horrific chemicals that can cause long-term problems.

Chemically Made Metallic Chlorides can kill cells on contact.

To clarify, Sodium Chloride (common table salt), is a relatively safe compound and the body requires a certain amount of it to maintain good health. Yet metallic chlorides (metals bound together with the deadly element Chlorine, which is a gas), are hazardous to the body and can damage or kill cells on contact.

While silver has many known beneficial properties, silver chloride does not.

Metallic mineral salts, like silver chloride, are electrically conductive.

Evidence indicates that mineral salts left behind by water purification processes help to generate sparks from submerged electrodes utilized to make some colloidal silver products.

New Colloidal Silver Products Made with Herbal Extracts

New gimmicks have developed to make Low PPM products "APPEAR" to be organic. Developers of these products use Herbal Extracts (Catalysts) which is supposed to qualify the products as being "Organic."

The problem with Herbal extracts is that they too contain salts and other minerals that will generate other chemical compounds once the Low PPM Electrolysis process is applied, and may also have adverse consequences.

Whichever way you look it at, the PPM is still too low, and the particles size are still very massive.

Producers of low PPM colloidal silver products have to use chemicals or some kind of a catalyst to get their nanoparticles to stay suspended in the solution. Consequently, the chemicals they use gets absorbed into the body first.

When the body tries to assimilate their nanoparticles, it cannot efficiently absorb them because the particles are too large as well as heavy and have a tendency to sink to the bottom of the stomach, where a prolonged continuous chemical process takes place as the hydrochloric stomach acids try to dissolve the silver nanoparticles and further creating silver compounds in the stomach.

Also, after an extended stay in the stomach, the larger particles usually excreted from the body. Upon excretion, the nanoparticles can get trapped and build up in the kidneys along with other mineral deposits. Such deposits may develop over time into kidney stones and could even cause kidney failure. A person can avoid all of these serious side effects by only ingesting chemical-free atomic particle size colloidal solutions.

Many producers of low PPM colloidal silver solutions remain in constant denial.

It’s in their best interest to maintain the idea that "it's impossible to make atomic size particles of silver" BECAUSE THEY WILL LOSE MARKET SHARE; these same producers continue to immortalize this belief to protect their market share selling their inferior products.

Regardless of their views, the fact is, our company has successfully made atomic size particles of silver and has repeatedly proven this by independent laboratory verification.

Make No Mistake Colloidal Silver is GREAT for fighting viruses and bacteria, but cheap, low quality chemically made silver is not ther right answer!


Avoiding Chemically Laced Colloidal Products

This list defines the types of Colloidal Silver Solutions to avoid:

1. Colloidal Silver solutions that exhibit any color or opaque hues in their bottles or containers are not to be trusted. Colored solutions are often found in Ionic and Nano-particle products. Consumer beware!

2. Various colloidal silver solutions with concentrations ranging from 10 to 400 PPM, having label instructions informing you not to do certain things, or that they’re not necessary. (See the highlighted items in 3-6 below).

3. Any colloidal silver products stating Do Not Refrigerate or No need to refrigerate should be avoided.

4. Colloidal silver solutions with instructions stating Do not expose to Sun or Ultraviolet light should be
passed over and not bought or used.

5. Nano or Ionic Silver solutions with labels stating Do not expose to high heat conditions are inferior, low-quality products not worth the cost they’re sold for.

6. Especially take notice of labels warning Do not apply externally to the skin, it would be wise to not even touch what’s in those bottles or containers.

7. Alert consumers should also avoid colloidal silver products that are stored in dark amber bottles, opaque plastic bottles or are covered with aluminum foil for UV protection.

8. Colloidal Silver kits designed so you can make your own solutions at home have limited abilities. They may inadvertently produce chemicals when used, which is undesirable and unhealthy. Silver particles produced from the electrodes of the kits are ionic or nano-sized particles. Both of these are too large for the body to assimilate and become harmful if ingested. If you cannot make atomic-sized particles, don’t consider making any colloidal silver solution that will be taken internally. Limited topical use may be okay. For Best Results
Learn How to make your own with our products.

A special note of importance:

Anyone with credentials can report whatever they choose on paper.

This does not mean what you’ve read is true.

Significant claims with health-related products need to be backed up with independent verification. Without such verification, a lot of companies will use deceptive practices to make inferior products that have harmful ingredients.

The largest and best Analytical Laboratories won’t tolerate dealing with dishonest companies as they’re not willing to jeopardize their reputations in the industry. Any company found falsifying or purposely misrepresenting one of their analytical reports, are barred from ever using the Lab’s analytical services again.

This is the reason most companies don’t use such services because they’d be exposed and people wouldn’t want to buy their products knowing what was really in them.  

Testing your colloidal silver for chemicals

The fastest way to test your Colloidal Silver is very easy to do:

If you have a bottle that you cannot see through, empty the contents into a Clear Glass that you can see through.

  1. Place in the freezer and let it freeze
  2. After Frozen, let it colloids thaw out
  3. You can also heat your solution on a stove for a minute or two, then let it cool
Observation of the Colloidal Silver Chemical Reactions:

You will find that the chemicals and nanoparticles dropped to the bottom of the vessel and are rendered useless.


Ours are 100% Natural, No chemicals or herbal natural catalysts are ever used!

"Just because others can't make it,
does not mean it cannot be done."